| The AT3515 is an entry-level
low cost solid-state flash drive.
Its cost effectiveness and low power
operation make the AT3515 ideal for applications requiring
high reliability at a
low cost up to 8 Gbytes of data storage.
Low profile 3.5" drive form-factor with 40-pin, 2.54 mm
grid IDE interface.
The drive supports up to PIO Mode-4 and DMA
Mode-2 bus access, multi-sector transfers, as well as LBA
addressing.
128 MByte to 8 GByte uncompressed capacity.
For the following temperature ranges (operating) available:
Commercial (0°C to +70°C)
Extended (–20°C to +75°C)
Industrial (–40°C to +85°C)
Storage temperature (non-operating) from –55°C
to +125°C.
Completely solid state – no moving parts.
An integrated 72-bit Reed-Solomon error detection and correction
mechanism and proprietary remapping and wear-leveling technology
along with a power hold-up circuit greatly improve data reliability.
5 volt, low power operation.
1000 G operating shock; 15 G operating vibration.
Sustained sequential read throughput is 6 MBytes/sec
and 6 MBytes/sec for writes.
10 year data integrity.
Pending CE and CSA/UL compliant.
Exclusive distributor for Germany,
Austria and Switzerland is altec ComputerSysteme
GmbH. | |
Versions (with item number)
128 MB AT3515 Bulldog –
B40MT128
256 MB AT3515 Bulldog –
B40MT256
512 MB AT3515 Bulldog –
B40MT512
1024 MB AT3515 Bulldog –
B40MT10
2048 MB AT3515 Bulldog –
B40MT20
4096 MB AT3515 Bulldog –
B40MT40
8192 MB AT3515 Bulldog –
B40MT81
Other memory capacities as shown above are also available. Please
ask for further details.
What are Solid State Disks?
The common feature of all Solid State Disks is that
the data is stored on Flash chips.
Solid State Disks are insensitive to shock, vibration,
temperature effects and extreme air pressure changes
and are highly resistant to EMC and ESD.
Solid State Disks do not have sensitive
rotating components. They are totally silent
in operation and have a low current consumption.
You can write, read and delete the data just like
a conventional hard disk. Mechanical hard disks
in mobile systems and industrial computers can be replaced
by pin-compatible Solid State Disks.
Memtech Solid State Disks
A Wear-Leveling Algorithm is
implemented in all drives, as well as the Kicker™ Hold
Up Circuit intended to prevent drive destruction
if writing is suddenly interrupted.
Every drive is subjected to Memtech’s exacting EnduroTest™ in
which each drive is fully tested under environmental
and voltage extremes to guarantee data integrity under
even the harshest conditions.
Optionally, all products are available with a Security
Erase feature and with a Conformal
Coating to protect them against moisture. | |
