| The AT2550
solid-state flash drive is an UDMA-66 compliant IDE memory
module offered in an extremely low profile 2.5 inch drive
form-factor.
The primary storage media in the drive is sector-erasable
NAND E2PROMs (Flash).
Using these devices, Memtech is able to deliver up to 27 GBytes
of uncompressed, non-volatile solid-state storage in an extremely
small, rugged form-factor.
Low profile 2.5" drive form-factor with 44-pin, 2 mm
grid UDMA-66 compliant IDE interface. ATA-6 compliant.
The drive supports advanced PIO, DMA and UDMA transfer modes,
multi-sector transfers, and LBA addressing.
4.8 GByte capacity under 9.5 mm; 8.7 GByte
capacity under 12.5 mm; 27 GByte
maximum capacity.
For the following temperature ranges (operating) available:
Commercial (0°C to +70°C)
Extended (–20°C to +75°C)
Industrial (–40°C to +85°C)
Military (–55°C to +125°C)
Storage temperature (non-operating) from –55°C
to +125°C.
Completely solid state – no moving parts.
16 byte CRC/ECC and Active Remap™ for
exceptional data reliability.
5 volt, low power operation.
1000 G operating shock; 15 G operating vibration.
0.1 millisecond random access time.
26 MByte/sec cached read performance.
20 MByte/sec cached write performance.
8 year product warranty.
8 million erase/write cycle endurance.
Exclusive distributor for Germany,
Austria and Switzerland is altec
ComputerSysteme GmbH.
|
|
Versions (with item number)
1024 MB AT2550 Wolverine –
35MT10
2048 MB AT2550 Wolverine –
35MT20
4096 MB AT2550 Wolverine –
35MT40
8192 MB AT2550 Wolverine – 35MT81
16384 MB AT2550 Wolverine
– 35MT163
27904 MB AT2550 Wolverine
– 35MT279
Other memory capacities as shown above are also available.
Please ask for further details.
What are Solid State Disks?
The common feature of all Solid State Disks is that the data
is stored on Flash chips. Solid State Disks are
insensitive to shock, vibration, temperature effects and
extreme air pressure changes and are highly resistant to
EMC and ESD.
Solid State Disks do not have sensitive
rotating components. They are totally silent in
operation and have a low current consumption.
You can write, read and delete the data just like
a conventional hard disk. Mechanical hard disks
in mobile systems and industrial computers can be replaced
by pin-compatible Solid State Disks.
Memtech Solid State Disks
A Wear-Leveling Algorithm is implemented
in all drives, as well as the Kicker™ Hold
Up Circuit intended to prevent drive destruction if
writing is suddenly interrupted.
Every drive is subjected to Memtech’s exacting EnduroTest™ in
which each drive is fully tested under environmental and
voltage extremes to guarantee data integrity under even the
harshest conditions.
Optionally, all products are available with a Security
Erase feature and with a Conformal
Coating to protect them against moisture. |
|
